MUTOH Rockhopper 3 Extreme Manual de instrucciones descargar pdf (Pagina 19)

Operation Instructions Rockhopper 3 Extreme

CHAPTER 3 : BASICS

AP-77150 – Rev. 2.0

3 BASICS

3.1 POWERING ON CYCLE

Caution

EFORE POWERING

THE PRINTER

MAKE SURE THAT THE WASTE BOTTLE IS INSTALLED AND THAT THE WASTE

TUBES ARE CONNECTED TO THE WASTE BOTTLE.

Power ON the printer according to the procedure below:

Step 1 : Press the [POWER] key of the operation panel.

The POWER lamp of the operation panel will light (green).

Step 2 : The printer will ask if you want to clean the wipers. When it is the first start up in a few hours, it is

highly recommended to press [YES] – [F2] and to clean the wipers with Mutoh Eco-Solvent Ultra

cleaning in order to remove all ink and to make the wipers more elastic.

Step 3 : Press the ENTER key when you have done. The carriage will cap in again.

Step 4 : After finishing the daily maintenance, the print will automatically perform a normal cleaning.

Step 5 : After finishing the cleaning cycle, the media measurement screen will be displayed (in case there

is media loaded)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 65 66

Sin comentarios

MUTOH Rockhopper 3 Extreme Manual de instrucciones Pagina 19