MUTOH Rockhopper 3 Extreme Manual de instrucciones descargar pdf (Pagina 20)

Operation Instructions Rockhopper 3 Extreme

CHAPTER 3 : BASICS

AP-77150 – Rev. 2.0

Step 6 : Make the correct settings and press the [F4]-key to start the media initialization.

Step 7 : If everything is done correctly, the following screen should appear..

Notes

F THERE ARE ANY PROBLEMS DURING THE INITIAL START

UP OPERATION

THE PRINTER WILL DISPLAY A MESSAGE ON

THE OPERATION PANEL

, AND THE OPERATION MAY STOP. IF THE OPERATION STOPS,

REFER TO

ROUBLESHOOTING

AND TAKE THE APPROPRIATE ACTIONS

Step 8 : Before start printing, be sure to perform a nozzle check to ensure all nozzles are present. If not,

perform the necessary cleaning cycles.

3.2 POWERING OFF CYCLE

Power OFF the printer according to the procedure below:

Notes

LEASE BE SURE TO PERFORM THE NECESSARY MAINTENANCE BEFORE POWERING

OFF

THE MACHINE

LL DETAILS

CAN BE FOUND IN CHAPTER 4.

Step 1 : Verify the following regarding the operational condition of the printer:

Ø There is no printing operation being performed.

Ø The operation panel is in the main screen.

Step 2 : Press the [POWER] key of the operation panel to switch OFF the printer.

Step 3 : [Power OFF] will be displayed for a few seconds

Ø Following message is displayed on the operation panel.

Ø All lamps and the LCD of the operation panel will switch OFF.

Ø The printer will automatically perform a TubingFlush and power OFF.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 65 66

Sin comentarios

MUTOH Rockhopper 3 Extreme Manual de instrucciones Pagina 20