MUTOH Rockhopper II Series Especificaciones descargar pdf (Pagina 186)

Rockhopper II series printers – Maintenance Manual

187

AP-74065, Rev. 1.2, 27/09/04

5.9.2. PF Motor Endurance Menu

This menu performs endurance running for the PF motor.

You can drive the PF motor according to your desired settings. The available settings are shown below.

Setup item Description Parameters Remarks

Media feed amount Sets amount of media

feeds per endurance

operation.

0 to 100 Unit: mm

Number of endurance

running cycles

Set the number of

endurance running

cycles

-1 to 10000

Notes :

¾ The motor drive parameters are determined as follows depending on the media feed

amount.

Speed 54 cps

Acceleration 0.1 G

Deceleration 0.1 G

¾ If the number of endurance running cycles is set to -1, the units continuously repeat

endurance running until a key input is given from the operation panel.

¾ The maximum counter value for endurance running cycles is 99999999 (up to 8-digit

number). If the number of cycles exceeds the maximum value, the counter is reset

to 0.

* FeedAmount *

0 – 100.0 mm + Media feed amount

0.1 mm -

↓ ENTER

* LifeCount *

Count

-1 → 10000 +

Number of endurance running cycles

50 -

↓ ENTER

* PFmotor *

Count 5 Perform endurance running

↓ ENTER

* PFmotor *

End 50

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 318 319

Comentarios a estos manuales

Sin comentarios

MUTOH Rockhopper II Series Especificaciones Pagina 186

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo MUTOH Rockhopper II Series