MUTOH Rockhopper II Series Especificaciones descargar pdf (Pagina 216)

Rockhopper II series printers – Maintenance Manual

217

AP-74065, Rev. 1.2, 27/09/04

Step 5 : Check if the buzzer sounded and whether the firmware was installed correctly.

Step 6 : Power the unit OFF.

Important :

After installation of the firmware onto the Rockhopper II 4 heater, you must

upgrade the heater system board.

(3) Updating the heater system board (4 heater printers ONLY!).

To update the heater system board of a Rockhopper II 4 heater printer, please follow the instructions

mentioned below.

Important :

¾ Before updating the heater system board, make sure you already installed the

firmware into the Rockhopper II 4 heater printer.

Step 1 : Make sure the printer is OFF.

Step 2 : Press simultaneously the [CANCEL] and the [ENTER] key while turning the printer ON.

Step 3 : The display will mention the following message.

* User Setting *

Rem Update

F2 →

Ver Update

(1/1)

Step 4 : Press the [F2] key.

Step 5 : The heater system board is now being updated. The display will mention the following

messages.

 Erasing sectors

 Wait flash programming

Step 6 : At the end the display will mention the following message.

Card Update

DO NOT POWER DOWN

Version Installed

Step 7 : Press the [CANCEL] key.

Step 8 : Power OFF the unit.

Step 9 : Updating the heater system board is completed.

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 318 319

Sin comentarios

MUTOH Rockhopper II Series Especificaciones Pagina 216